Electric Inking Systems

Electric Inking Systems See Inking Applications for Specific Application Information Drawing Prefix Key: EG = Electroglas Prober Application: KLA = KLA Prober Application: TSK = Tokyo Semitsu Prober Application: PWS= Pacific Western Systems Application: LT = Laser Trimmer Application Complete Dimensional Drawing List
Series 100 Cabled Probe, laser trimming, optical inspection Coarse X, Y positioning Vertical positioning via slide bracket and adjustment knob Quick dismount for probe card changeout For 5 mil applications, use an H2 model Holder with plunger adjustment EG 101 Inker Base KLA 103 Inker Base PWS 102 Inker Base TSK 104 Inker Base LT 105 Inker Base LT 106 Inker Base	Cartridge Holders A wide range of models are available. All use DieMark^® disposable cartridges. Some models are used in Xandex inkers while others are specifically designed to retrofit other marking brands. Retrofit of an existing inker is an inexpensive way to utilize the convenience and reliability of DieMark^® cartridges. Aluminum construction High temperature 12 or 24 volt coils with heat sink Cartridge spring clip Sturdy 6 or 7 mil spring plungers with retaining clip All models use DieMark® disposable ink cartridges Actuator to Holder Installation Screw Reference
Series 200 High frequency overhead test Underslung mounting for clearance Joystick for fine X, Y positioning Vertical adjustment via slide bracket and adjustment knob EG 201 Inker Base	DieMark^® Ink Cartridges Electric inkers utilize DieMark^® cartridges for the ultimate inking solution. DieMark^® cartridges offer reliable, consistent, trouble free operation with the benefit of a disposable unit. Pre-filled factory tuned cartridges are easy to use - no adjusting, refilling or cleaning. All inks utilized in the cartridges have been selected to produce consistent dots over a wide range of speeds without dripping, or skipping. Three needle configurations are available to afford optimal visual/physical inker clearance. Large capacity reservoir for unattended multi-shift inking Reliable soft contact inking - no damage to the wafer Three needle types: DM-1 (.75"), DM-1.25 (1.25") and DM-S (curved) Dot sizes 5, 8, 10, 15, 25, 30 mil Low containment, heat set, air dry, phenolic and epoxy type inks More Ink and Cartridge Information Ink and Cartridge Installation and Operation Manual
Series 300 Cabled probe, optical inspection Joystick for fine X, Y positioning Vertical adjustment via slide bracket and adjustment knob For 5 mil applications, use an H2 model Holder with plunger adjustment EG 301 Inker Base KLA 303 Inker Base PWS 302 Inker Base
Series 600 Cabled probe, off-line and post-probe inking High-speed solenoid - up to 10 dots per second Joystick for fine X, Y positioning Flip-up manipulator for quick probe card and cartridge change out EG 601 Inker Model KLA 603 Inker Model LT611 Inker Model
Plunger Stop Assembly Data Sheet The 5 mil DM-1 cartridge requires a very short plunger stroke in order to minimize the amount of ink flow to the filament tip and ensure consistent, problem free performance. In order to shorten the plunger stroke when using the 5 mil DM-1 application, the cartridge holder must be retrofitted with a Plunger Stop Assembly. This assembly is available for all H series cartridge holders. After the cartridge holder is retrofitted with the plunger stop assembly, it can still be used with any DM-1 cartridge size as long as the plunger stop is backed off completely to allow full plunger travel.